Beautiful Change Normal Switch To Dimmer

To replace a standard switch with a dimmer switch follow these steps.

Change normal switch to dimmer. Secure it by tightening the screw then attach the traveler and or common wires from the switch box to the screws at the sides of the new switch in the same manner. The black wire to the lone screw on the 3 way light switch. Wiring a light switch to replace a dimmer switch.

Discuss changing a dimmer switch to a normal switch help needed please. Next using a pair of needle nose pliers wrap the bare ground wire around the green screw at the bottom of the new standard switch. Mount the dimmer to the box using the two provided screws.

Loosen the screw that holds the grounding wire to the switch and remove the dimmer switch from the switch box. Then use a voltage tester to make sure that the circuit is dead. Of course such a replacement should be done by a registered electrician don t try to do any diy with electricity and electrical devices such as these so that it may be tested and work properly.

The typical connections are as follows. Disconnect the traveler and or common wires from the dimmer switch. Unscrew the switch from the electrical box and pull it out with the wires still attached.

Either unscrew the wire nuts on the dimmer switch wires or loosen the screws holding the wires in place. Fit the new dimmer cover plate into place and secure it to the box or switch as applicable with the provided screws. Turn off the power to the switch at the circuit or fuse panel.

Pull the new single pole light switch out of the box and locate the two power wire connections and the ground connection. Carefully tuck the wires into the electrical box folding them neatly as needed. It is a normal size as a regular dimming module so it can easily replace the existing dimmer in the back of your dimmer switch.