Amazing Connecting Multiple Lights To One Switch

At sw1 it is connected to one of the terminals.

Connecting multiple lights to one switch. Connect the black wire from it to the other screw on the switch and the ground wire to the box as. All you need to do is to identify the anode positive and the cathode negative ends of each led strip. The power supply connects to the first light.

On the last fixture lead the outgoing wire down the wall to the junction box for the light switches allowing an additional 8 inches of wire. Basically the simplest way to have multiple lights on one switch is to run a power supply wire to the switch first. Strip of an inch off of the end of this wire.

The new cable here is labelled light 2. If they do do stp then only one of the switch to switch links will be used. Adding an extra cable to the existing ceiling rose.

Connect the white wire from the power supply to the white wire from the light. Secure the light fixture to the junction box for the light following the instructions from the manufacturer. The white wire is marked black on both ends to identify it as hot.

Connect the black wire from the switch to the black wire from the first light. Now run a two wire cable from the first light location to the switch box. Do this for each light fixture.

The neutral from the source is connected directly to the neutral terminal on the light and the source hot is spliced with the white loop wire. You can also do a home run configuration by feeding all the cables to the switch and connecting them with a pigtail. Learning how to connect multiple led strips to one power source shouldn t necessarily jade you if you opt for the series circuit.